Description

RÖHM drill chuck

For clamping shanks from 0.5 – 6.0mm. High speed accuracy (allowed up to 10,000rpm). 3/8″ thread: to be used on bench drill machine TBX. Incl. drill chuck key.

 NO 68 122

XENOX machine vice MSX

Made of die-cast ZINC. With a slot as fit for the adjustable stop of the bench drill machine TBX. With three machined sides. Vertical and horizontal V-slots in jaw for holding round material. Jaw width 50mm and height 10 mm. Maximum clamping width 34mm.

 NO 68 132

Flexible support plate

For drilling spectacle lenses. With thread and square nut for the T-slots of the MICRO compound table KTX. Can also be clamped with machine vice MSX (horizontal V-slot available). Outer diameter 16mm, tapped hole diameter 7mm. Support height 18mm, made of solid plastic.

NO 67 101

XENOX steel collets

For use with motor handpieces MHX and MHX/E as well as for the bench drill machine TBX. Triple slit. Hardened and with high, consistent flexibility. The precondition for centrical clamping and high concentricity of the accessories. One each for shanks 1.0 – 1.5 – 2.0 – 2.35 – 3.0 and 3.2mm in a practical holder.

NO 68 940